How to Reset Power-On Password on HP Desktop - Jumper Location

Resetting the Power-On Password on HP Desktop - Jumper Location

When you encounter a situation where you need to reset the power-on password on your HP desktop, accessing the jumper location is crucial.

Firstly, ensure you have the necessary tools such as a screwdriver and anti-static wrist strap. Follow these steps:

1. Power off your HP desktop and unplug all cables.
2. Open the computer case by removing the side panel screws and sliding it off.
3. Locate the BIOS password jumper on the motherboard. It is usually a 2-pin jumper with a small plastic sleeve.
4. Move the jumper from its current position to the opposite pins. For example, if it is on pins 1 and 2, move it to pins 2 and 3.
5. Wait for a few seconds, then move the jumper back to its original position.
6. Close the computer case, plug in all cables, and power on your HP desktop.
7. The power-on password should now be reset, and you can access your system without entering a password.

Remember to set a new power-on password in the BIOS settings to secure your desktop.